null
Categories
Brands
Navigate
Victron SmartSolar MPPT RS 450V/200A Charge Controller Front View

Victron SmartSolar MPPT RS 450V/200A Charge Controller

$2,281.00
$1,938.85
SKU:
1593133
Spec Sheet:
Manual:

Maximize Your Solar Efficiency with the Victron SmartSolar MPPT RS 450V/200A Charge Controller

The Victron SmartSolar MPPT RS 450V/200A Charge Controller is designed to optimize energy harvest from high-voltage PV arrays while ensuring reliable battery charging. Perfect for 48V battery banks, it offers advanced features for efficient power management and system integration.

 

Key Features:

  • Ultra-Fast MPPT Technology: Tracks the Maximum Power Point quickly to maximize energy capture. Supports PV arrays with a voltage range of 65V – 450V Voc.

  • High-Capacity Battery Charging: Charges 48V battery banks at 100A or 200A. Fully programmable for various battery chemistries (lead-acid, lithium, etc.).

  • Easy Setup & Monitoring: Bluetooth connectivity via VictronConnect for configuration and monitoring. Track battery voltage, current, PV voltage, and historical trends.

  • Scalable & Expandable: VE.Can bus ports enable daisy-chaining with additional MPPT units. Synchronizes charge stages across connected controllers.

  • Remote Management: Full remote access through Victron Remote Management Portal (VRM). Internet-based monitoring with GX devices or offline access via GlobalLink 520.

  • Built-In Display & Advanced Features: Front panel display shows battery voltage, charge current, and PV performance. Supports remote temperature/voltage sensing and programmable relay.

 

Daisy Chain Additional Units

The SmartSolar RS charge controller is equipped with VE.Can bus ports. This allows for communication with additional SmartSolar RS & VE.Can MPPT units. The additional units are simply “daisy chained” to each other with an RJ45 cable.
When connected to each other, all individual charge controllers, will synchronise their charge stages. They can also send their data, via the same cable, for monitoring to a GX device (such as the Cerbo GX).
 
 

Setup and Monitor with VictronConnect

The SmartSolar RS charge controller can be remotely controlled and configured over Bluetooth via the VictronConnect app. This allows device set-up, management, and at-a-glance information, such as battery voltage and current, PV voltage and current, historical data and trends.
 

SmartSolar Display

The SmartSolar RS charge controller is equipped with a display on the front panel. The display reads battery volts, charge current and voltages from both array’s individually including instantaneous and total figures and unit status including any possible error codes.
Spec Sheet:
Manual:
5 Year Limited Warranty

Related Products